| The ANIMATE BOARD is a 9 Volt dc powered full feature
Sound, Motion and Switched ON / OFF output control interface
board.
The controller has on-board sound recording and playback in
to a 20 second sound chip with microphone and speaker
output and up to 40 seconds of recorded and playback
motion saved to a EEPROM for 4 standard +5 Vdc servos and
control of 4 digital switched ON and OFF outputs at + 4.5 Vdc
(100 mA) per channel action.
The Animate board incorporates many features such as looping
playback servo motion with variable delay between loops. An auto
start-up on power option and on board connector for remote activation
switching such as a PIR sensor, contact switch or mat pressure
pad to initiate servo playback and on- board sound output.
Recording sessions are built up on a channel by channel process
- no complex programming is required.
During recording, all previously recorded channels are re-played
to aid synchronization the current channel being programmed.Programming
is easily done, with a set of push button keys and control potentiometer
built onto the board.Speaker connection terminal allow the addition
of an 8-16 ohm speaker which can be driven directly from the
Animate board .Motion, Sound and Switched ON / OFF outputs are
all controlled from a single board.Connection pins on-board for
servos, output hookups.
Programmable Servo Recording time - 40 Seconds
Programmable Sound Recording time - 20 Seconds
( 9 Volt dc - 2 Amp Power Supply, Servos and Speaker not included
).....Board Size: 5" L x 4-3/16" W
Power : 9 Volt dc @ 2 Amp.
Controller has 7-bit Resolution.
Animate Board is pre-assembled and tested.
|
