| Control Board will record and playback up to 5 minutes
of servo motion for 2 standard 5 Vdc hobby R/C type servos and
record and playback 2 digital Solid State Relay switched ON and
OFF output.
The board incorporates many features such as looping playback
servo motion with variable delay between loops. An on board connector
for remote activation switching such as a PIR sensor, contact
switch or mat pressure pad to initiate playback.
Recording sessions are built up on a channel by channel process
- no complex programming is required. During recording, all previously
recorded channels are re-played to aid synchronization the current
channel being programmed. Programming is easily done, with a
set of push button keys and control potentiometer built onto
the board.
No host computer or other programming device is needed to operate
the board,
Duo Power supplies, Servos, not included.
( 9 Volt dc @ 800mA power supply needed )
( 5 Volt dc @ 2 Amp power supply needed )
Specifications:
- 2- Digital channel- Solid State Relay output rated 2 Amp
(On/Off Control).
-
2- Servo channels Operate R/C servos
-
Potentiometer to adjust the servo positions.
-
Programmable Recording time - 5 Minutes
-
Potentiometer to adjust the time delay between loops in loop-play.
-
Programming Buttons RELAYS ON-OFF, SERVOS, RECORD buttons.
-
Record enable/disable jumper, EEprom protection switch
-
Remote start option- for switches, sensors / PIRs, etc
-
Many more features.
Board Size:
5-1/2" Long x 3" Wide x 1-3/8" High
Controller Requires Duo Power:
5 Vdc @ 2 Amp Power Supply and
9 Vdc @ 800 mA Power Supply ....
Board is pre-assembled and tested |
