| Controller Board will record 3-(12.5 minutes each routine)
and playback the 3 different programmed servo routines to one
standard hobby R/C type servo when activated. Manual operated
on board Solid State digital relay has switched ON and OFF output.
3 - different servo control routines are pre-recorded into memory
by the user. Programmed routines are then played back to servo
by selecting 1-3 manual playback switch, or setting the board
to looping or sequence function.
Board can be set to sequence function, where each servo routine
is played back as channel 1 is activated. On board looping playback
feature lets board run automatically. On board relay and servo
routinesi can be activated by maual switch, remote relays or
even by wireless hand held control.
Recording sessions are built up on a channel by channel process
- no complex programming is required. Programming is easily done,
with a set of switches and a control potentiometer built onto
the board.
No host computer or other programming device is needed to operate
the board.
Board is triggered by manual switches, remote relays or even
by wireless hand held control.
Duo Power supplies, Servos, not included.
( 9 Volt dc @ 800mA power supply needed )
( 5 Volt dc @ 1 Amp power supply needed )
Specifications:
- 1- Manual operated Solid State Relay output rated 2 Amp (On/Off
Control).
-
1- Servo channels Operate R/C servo
-
3- Programming memory modules (12.5 minute record time each)
-
Potentiometer to adjust the servo positions.
-
Switch connection terminal blocks on board.
-
Many more features.
Board Size:
4-7/8" Long x 3" Wide x 1-3/8" High
Controller Requires Duo Power:
5 Vdc @ 1 Amp Power Supply and
9 Vdc @ 800 mA Power Supply ....
Board is pre-assembled and tested. |
