DMX - Receiver Module
The DMX receiver module is designed to provide 8 consecutive
channels of output from a standard DMX protocol input signal.
The outputs may be configured to be digital (on-off), drive standard
RC type servos, provide triggering outputs suitable for driving
Triac lamp dimmer circuits- or a combination of any two of these.
The base address of the module may be set from 8 to 248 using
the on-board setting jumpers.
DMX Bus
Twin connectors are provided for connecting the module into the
DMX signal system. The twin connectors are wired in parallel.
The outputs are each 5V TTL level with a 470 ohm series resistor
to limit current draw from the processor. The maximum current
rating from the processor chip pins is 20mA sink or source with
a total of 60mA.
Unit comes with user manual and assembled board. Tested and ready
for use.
DMX In-Out: 3-pin XLR connectors
Power supply not included. ( 9 Volt dc @ 1 Amp)
PCB Size:
85mm x 80mm x 30m high
(3.3" x 3.15"x 1.2")
